Many people are claiming that cannabis oil is a miracle cure for conditions like epilepsy, cancer, diabetes and multiple sclerosis, especially after conventional medicine proved to be unsuccessful.
According to Rick, hemp oil rejuvenates vital body organs which helps individuals that use it feel 20-30 years younger during the initial stages of treatment. Keep in mind that use of hemp must be used in the right proportions and doses.
Hemp oil will lower blood pressure and if you are on blood pressure medication, you may find that this medication is no longer needed. The same is true for diabetics. I have seen hemp oil control blood sugar to the extent that insulin was no longer needed.
Rick Simpson is a guy from Canada who’s story tells that he cured his own skin cancer using a very specific method of making an oil concentrate from the cannabis plant. He recommends ingesting the oil orally for a period of 90 days depending on the condition you are treating.
Read: 8 Foods That Heal The Pancreas System And Produce Digestive Enzymes
Rick Simpson’s Hash Oil Recipe:
Place the completely dry material in a plastic bucket.
Dampen the material with the solvent you are using. Many solvents can be used. You will require about two gallons of solvent to strip the THC off one pound of dry starting material. 500 milliliters of solvent should be more than enough to strip the THC from one ounce of starting material.
Crush the plant material using a stick of clean untreated (chemical free) wood or some such device. Even though the starting material has been dampened with the solvent, you will find that the material can be readily crushed.
Continue to crush the material with the stick, while adding solvent until the plant material is completely covered and soaked. Remain stirring the mixture for about three minutes.
As you do this, the THC is dissolved off the material into the solvent.
Pour the solvent-oil mix off the plant material into another bucket. You have just stripped the plant material of about 80% of its THC.
Second wash: again add solvent to the mixture and work for another three minutes to extract the remaining THC.
Pour the solvent-oil mix through a coffee filter into a clean container.
Discard the twice washed plant material.
Pour the solvent oil mixture through a coffee filter into a clean container.
Boil the solvent off: a rice cooker will boil the solvent off nicely, and will hold over a half gallon of solvent mixture.
Add solvent-oil mix to the rice cooker until it is about ¾ full
As the level in the rice cooker decreases for the last time, add a few drops of water (about 10 drops of water for a pound of dry material).
This will help to release the solvent residue, and protect the oil from too much heat.
When there is about one inch of solvent-water mixture in the rice cooker, put on your oven mitts and pick the unit up and swirl the contents until the solvent has finished boiling off.
When the solvent has been boiled off, turn the cooker to LOW heat. At no point should the oil ever reach over 290˚ F or 140˚ C.
Keep your oven mitts on and remove the pot containing the oil from the rice cooker. Gently pour the oil into a stainless steel container
Now put the stainless steel container in a dehydrator, or put it on a gentle heating device . It may take a few hours but the water and volatile terpenes will be evaporated from the oil. When there is no longer any surface activity on the oil, it is ready for use.
Pour the hot oil into a bottle; as it suck up into a plastic syringe. Putting the oil in a plastic syringe makes it very easy to dispense the medicine.
CAUTION: Make sure you are in a very well ventilated area and set up a fan to carry the solvent fumes away. The fumes are very flammable. Be sure to stay away from red-hot elements, sparks, cigarettes etc. that could ignite the fumes.
Resources:
1) collective-evolution.com
2) cannabisni.com
3) rawmmc.com
